Chia Nan University of Pharmacy & Science Institutional Repository:Item 310902800/9278
English  |  正體中文  |  简体中文  |  全文笔数/总笔数 : 18074/20272 (89%)
造访人次 : 4161885      在线人数 : 6308
RC Version 7.0 © Powered By DSPACE, MIT. Enhanced by NTU Library IR team.
搜寻范围 查询小技巧:
  • 您可在西文检索词汇前后加上"双引号",以获取较精准的检索结果
  • 若欲以作者姓名搜寻,建议至进阶搜寻限定作者字段,可获得较完整数据
  • 进阶搜寻


    jsp.display-item.identifier=請使用永久網址來引用或連結此文件: https://ir.cnu.edu.tw/handle/310902800/9278


    標題: 利用TiO2/Apatite光觸媒處理水中酚及胺基酸之研究
    Study on the treatment of phenol and amino acid in aqueous solution via TiO2/Apatite photocatalyst
    作者: 潘志明
    Chih- Ming Pan
    貢獻者: 林秀雄
    嘉南藥理科技大學:環境工程與科學系碩士班
    關鍵字: 光催化反應
    擔體光觸媒
    含酚廢水
    甘胺酸
    glycine
    phenolic wastewater
    TiO2/Apatite
    photo catalysis
    日期: 2007
    上傳時間: 2008-12-03 11:18:37 (UTC+8)
    摘要: 本研究利用TiO2進行光催化反應去除水中有機物。本研究主要目的有為:以溶膠-凝膠法製備二氧化鈦及氫氧磷灰石,利用二氧化鈦經紫外光照射後產生氧化作用,以及磷灰石對有機物可吸附之特性將二者結合,以酚與甘胺酸為反應物,使用不同比例二氧化鈦/磷灰石所合成之觸媒,由上述反應物去除率篩選最適之TiO2/Apatiet光觸媒及最適之觸媒添加量。
    從實驗結果得知,當觸媒中TiO2含量高於Apatiet時,對水中的汙染物去除率也會增加,反之則相反。另外,從BET分析發現添加適量的聚丙烯可以增加磷灰石的比表面積,最適之磷灰石/聚丙烯比例為1:1。由分析實驗結果得知,TiO2/Apatiet光觸媒在二氧化鈦/磷灰石合成比例為5:1時,對水中酚反應效果為最佳,而TiO2/Apatiet光觸媒合成比例為9:1時,對水中甘胺酸反應效果為最佳,最適觸媒添加量均為0.75g/L。
    在前述最佳觸媒及最適添加量下,常溫、常壓下反應6小時,則100ppm酚轉化率可達45%,COD去除率則為24%,而50ppm酚在常溫、常壓下反應4小時,則酚轉化率可達55%,COD去除率則為35%。而100ppm甘胺酸之COD去除率則是50%。
    This study aimed at removing organics in aqueous solution via photo catalysis. A more efficient photo catalyst, i.e. TiO2/Apatite, was synthesized by the sol-gel method. The improved efficacy of TiO2/Apatite may be attributed to the combination of photo catalytic capability of TiO2 and absorption capability of Apatite. The organics tested were phenol and glycine (an amino acid) and their removing efficiency were based to screen for the optimal catalyst loading and composition of TiO2/Apatite.
    The results show that Apatite has the most BET surface area as it was prepared at Apatite/P.P. = 1:1. Moreover, for removing phenol, the optimal ratio of TiO2/Apatite is 5:1 while it is 9:1 for the removal of glycine. The most efficient catalyst loading is 0.75 g/L for both organics tested.
    Under the above mentioned optimal reaction conditions, the following efficiency was obtained. For 100ppm phenol, 45 % phenol conversion and 24 % COD removal was achieved after 6 hrs reaction;for 50 ppm, 55 % phenol conversion and 35 % COD removal was achieved after 4 hrs reaction;for 100 ppm glycine, 50 % COD removal was achieved after 4 hrs reaction.
    關聯: 校內校外均不公開
    显示于类别:[環境工程與科學系(所)] 博碩士論文

    文件中的档案:

    档案 描述 大小格式浏览次数
    index.html0KbHTML1582检视/开启


    在CNU IR中所有的数据项都受到原著作权保护.

    TAIR相关文章

    DSpace Software Copyright © 2002-2004  MIT &  Hewlett-Packard  /   Enhanced by   NTU Library IR team Copyright ©   - 回馈